Contact us now:   0488 886 301

5 Repair Solutions for Leaky Pipes

plumbercamperdown sewer shrubs

Homeowners usually face plumbing emergencies due to malfunctions or damaged components such as leaky pipes. This problem may seem to be a minor issue but can create a haywire situation if not repaired immediately. The little amount of water that seeps out can turn out to be gushing water once the leak exacerbates. However, there are different ways to restore its good condition. Listed below are some of the methods that you can use:

  1. Tighten the joints

It’s not all the time that a leak is caused by cracks on the surface of the pipe. There are instances that loose joints are the culprits of this problem. With this, it’s best to check the joints and pipe fittings aren’t tightened properly during its installation or repair. To repair it, you can use a wrench to tighten or adjust the joints of the leaky pipe.

  1. Hose clamp

An effective solution for leaking pipes is to invest on a rubber patch in the nearest local store. With the help of an automotive clamp, wrap the rubber and install it. Ensure that the rubber is at the top part of the leaky area. Tighten the clamp and the screw. Make sure that there’s a proper alignment of the clamp and rubber to fasten it on the top of the leak without difficulty. Opting for hose clamp can give a temporary solution.  

  1. Tape

For pinholes and small cracks, taping the pipe is an easy method to provide enough seal. Before doing this, you must locate the source of the leak first. After locating the leak, activate the shutoff valve to stop the flow of water. Then, use a rug to dry the pipe and start taping the pipe with the use of an electrical tape. To make sure that the tape doesn’t peel off easily, cover the pipe with the tape for at least 6 inches. Like using a hose clamp, this is also a temporary solution.

  1. Epoxy paste

If the leaks are found somewhere in the pipe’s fittings, using electrical tape and c-clamps may not be enough to solve the problem. An alternative for this is to utilise an epoxy paste. However, before making any repairs, you first have to activate the shut-off valve to avert the water from flowing into the pipes. Use a rag to dry the pipe. Then, get some epoxy paste and flatten it in your palm before you apply it on the leaky part. The paste should easily stick to the plastic or metal surface of the pipe. By using your thumb or a putty knife, put an epoxy paste into space between the fittings. Leave it for 20 – 25 minutes for the epoxy to settle.

  1. Compound stick

You can find compound sticks in your local home depot. Simply swab its tip to the crack of a leaky pipe. Use the shutoff valve if the leak allows water to gush out, soaking the pipes and the areas surrounding it.